P24F1 — Control module wake-up circuit signal too high
| Meaning | The control module found that the wire that wakes it up is at a higher voltage than expected, or stays active when it shouldn't. The exact circuit differs from one manufacturer to another. It can mean the module stays awake and drains the battery, or that it isn't getting a clean signal. |
| Family | Powertrain (P) |
Typical symptoms
Check engine light on
Irregular starting
Communication errors between modules
Odd behaviour of some functions with the ignition off
Common causes
A connected module holding the signal permanently active
Moisture or corrosion in the wiring or connector
A switch or relay stuck on
Internal fault in the control module
What to do
How to read code P24F1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24F1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (F1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24F1 mean?
Control module wake-up circuit signal too high. The control module found that the wire that wakes it up is at a higher voltage than expected, or stays active when it shouldn't. The exact circuit differs from one manufacturer to another. It can mean the module stays awake and drains the battery, or that it isn't getting a clean signal.
Can I keep driving with code P24F1 active?
With caution: limp mode possible, have it checked soon
Common causes — P24F1
Signal wire shorted to the power supply A connected module holding the signal permanently active Moisture or corrosion in the wiring or connector A switch or relay stuck on Internal fault in the control module
How do you fix code P24F1?
Check whether the battery runs down while the car is parked, and have the wiring and connector of the module inspected. Don't ignore this for long, because a battery that keeps going flat can leave you stranded. Don't unplug modules at random: it needs a diagnosis with the wiring diagram.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24F0 — Control module wake-up circuit signal too low
- Next code: P24F2 — EGR temperature and charge air temperature do not...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible