P24F2 — EGR temperature and charge air temperature do not match
| Meaning | The control module compares the temperature measured in the EGR (exhaust gas recirculation) circuit with the temperature of the charge air after the intercooler. Under certain conditions the two values should be close or follow a predictable pattern, and they don't. It can be a sensor reading wrongly or a cooling part not doing its job. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power or limp mode
Smoke from the exhaust or rough combustion
Higher fuel use than usual
More frequent particulate filter regeneration
Common causes
Damaged wiring or connector at the sensor
EGR cooler or intercooler dirty, blocked or leaking
EGR valve stuck open or closed
Leaks in the charge air piping
What to do
How to read code P24F2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24F2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (F2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24F2 mean?
EGR temperature and charge air temperature do not match. The control module compares the temperature measured in the EGR (exhaust gas recirculation) circuit with the temperature of the charge air after the intercooler. Under certain conditions the two values should be close or follow a predictable pattern, and they don't. It can be a sensor reading wrongly or a cooling part not doing its job.
Can I keep driving with code P24F2 active?
With caution: limp mode possible, have it checked soon
Common causes — P24F2
EGR temperature sensor or charge air temperature sensor reading out of range Damaged wiring or connector at the sensor EGR cooler or intercooler dirty, blocked or leaking EGR valve stuck open or closed Leaks in the charge air piping
How do you fix code P24F2?
Have both temperatures read on a scan tool with the engine cold: if they differ a lot, one sensor is suspect. Then check the hoses, the intercooler and the EGR valve. You can drive short distances, but with a loss of power it should be looked at soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24F1 — Control module wake-up circuit signal too high
- Next code: P24F3 — Reductant tank temperature and fuel temperature do...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible