P24FC — Particulate matter sensor heater drawing too much current or too hot
| Meaning | The particulate (soot) sensor has a small heater used to clean it. The control module found that the heater's control circuit draws too much current or gets too hot. As a protection, the heater may be limited and the sensor stops working well. |
| Family | Powertrain (P) |
Typical symptoms
Particulate filter fault message
No obvious driving symptoms in mild cases
Possible limp mode
Incorrect filter regeneration
Common causes
Damaged wiring or connector at the sensor
Faulty particulate sensor
Irregular supply to the circuit
Driver fault inside the control module
What to do
How to read code P24FC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24FC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (FC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24FC mean?
Particulate matter sensor heater drawing too much current or too hot. The particulate (soot) sensor has a small heater used to clean it. The control module found that the heater's control circuit draws too much current or gets too hot. As a protection, the heater may be limited and the sensor stops working well.
Can I keep driving with code P24FC active?
With caution: limp mode possible, have it checked soon
Common causes — P24FC
Sensor heater shorted or with resistance out of range Damaged wiring or connector at the sensor Faulty particulate sensor Irregular supply to the circuit Driver fault inside the control module
How do you fix code P24FC?
Have the sensor's connector and wiring checked and the heater resistance measured. If the sensor is worn out it needs replacing; don't work on the filter before ruling the sensor out. You can use the car for short trips, but it's best to have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24FB — Exhaust air purge valve control circuit high
- Next code: P24FD — Particulate filter A not as expected
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible