P24FD — Particulate filter A not as expected
| Meaning | The control module has determined that particulate filter A doesn't behave as a correct, healthy filter should. It may have been replaced with an unsuitable one, be damaged, or be missing internal parts. The code alone doesn't say which: more measurements are needed. |
| Family | Powertrain (P) |
Typical symptoms
Particulate filter fault message
Loss of power or limp mode
Unusual smoke or smell from the exhaust
Frequent regeneration, or regeneration that doesn't complete
Common causes
Filter damaged, cracked or with its internal substrate broken
Faulty differential pressure sensor or blocked sensing pipes
Exhaust leaks near the filter
Control module software out of date or not matching the fitted filter
What to do
How to read code P24FD
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24FD starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (FD) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24FD mean?
Particulate filter A not as expected. The control module has determined that particulate filter A doesn't behave as a correct, healthy filter should. It may have been replaced with an unsuitable one, be damaged, or be missing internal parts. The code alone doesn't say which: more measurements are needed.
Can I keep driving with code P24FD active?
With caution: limp mode possible, have it checked soon
Common causes — P24FD
Non-original filter or one not suited to the vehicle Filter damaged, cracked or with its internal substrate broken Faulty differential pressure sensor or blocked sensing pipes Exhaust leaks near the filter Control module software out of date or not matching the fitted filter
How do you fix code P24FD?
Have the filter and the differential pressure sensor with its small pipes checked, and make sure the fitted filter is the right one for the vehicle. Don't keep driving for long, because a damaged or unsuitable filter can get worse. Avoid any fix that alters the filter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24FC — Particulate matter sensor heater drawing too much...
- Next code: P24FE — SCR catalyst not as expected
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible