P24FE — SCR catalyst not as expected
| Meaning | The control module has determined that the SCR catalyst (the one that uses AdBlue to reduce nitrogen oxides) doesn't behave as a correct, healthy one should. It may be an unsuitable, worn or damaged part. The code alone doesn't say which. |
| Family | Powertrain (P) |
Typical symptoms
Emissions system or AdBlue warning message
Unusual AdBlue consumption
Possible power limitation
Restricted-start warnings on some vehicles
Common causes
Non-original part or one not suited to the vehicle
Incorrect AdBlue dosing from a dirty injector or a clogged nozzle
NOx sensors reading wrongly
Exhaust leaks before or after the catalyst
What to do
How to read code P24FE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24FE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (FE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24FE mean?
SCR catalyst not as expected. The control module has determined that the SCR catalyst (the one that uses AdBlue to reduce nitrogen oxides) doesn't behave as a correct, healthy one should. It may be an unsuitable, worn or damaged part. The code alone doesn't say which.
Can I keep driving with code P24FE active?
With caution: limp mode possible, have it checked soon
Common causes — P24FE
SCR catalyst worn or contaminated Non-original part or one not suited to the vehicle Incorrect AdBlue dosing from a dirty injector or a clogged nozzle NOx sensors reading wrongly Exhaust leaks before or after the catalyst
How do you fix code P24FE?
Before suspecting the catalyst, have the AdBlue quality and dosing, the NOx sensors and any exhaust leaks checked. If all of that is fine, the catalyst needs to be tested. Don't put it off too long, because the system can go into protection mode.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24FD — Particulate filter A not as expected
- Next code: P24FF — Reductant temperature too high
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible