B1397 — Door unlock circuit shorted to battery voltage
| Meaning | The body control module detected battery-level voltage on the door unlock circuit where there should be none, as if the wire were touching the battery positive. B1397 is a manufacturer-defined code: the exact meaning and the parts involved vary by brand, so this describes the fault only in general terms without naming a specific component. |
| Family | Body (B) |
Typical symptoms
Doors unlock by themselves or at random
Central locking works on only some doors
Relay clicking repeatedly
Battery going flat when the car sits
Body fault warning light or message on the dash
Common causes
Wiring pinched or worn where it passes between door and body pillar
Door lock actuator shorted internally
Connector with moisture or corrosion creating stray contact
Lock relay or control module with an internal fault
Earlier electrical repair done with incorrect connections
What to do
How to read code B1397
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code B1397 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code B1397 mean?
Door unlock circuit shorted to battery voltage. The body control module detected battery-level voltage on the door unlock circuit where there should be none, as if the wire were touching the battery positive. B1397 is a manufacturer-defined code: the exact meaning and the parts involved vary by brand, so this describes the fault only in general terms without naming a specific component.
Can I keep driving with code B1397 active?
With caution: limp mode possible, have it checked soon
Common causes — B1397
Unlock wire with damaged insulation touching a live wire Wiring pinched or worn where it passes between door and body pillar Door lock actuator shorted internally Connector with moisture or corrosion creating stray contact Lock relay or control module with an internal fault Earlier electrical repair done with incorrect connections
How do you fix code B1397?
First check the wiring where it passes between the door and the body, since that is the part that wears most. Then check the connectors and the lock actuators. It will not stop the car, but a short to positive can drain the battery or damage the module, so have it looked at soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: B1396 — Power door lock circuit: short to battery
- Next code: B1398 — Driver window one-touch relay circuit fault
Related codes
- B1300 — Power door lock circuit failure (B1300)
- B1301 — Power door lock circuit open (B1301)
- B1302 — Accessory delay relay coil circuit failure (B1302)
- B1303 — Accessory delay relay coil circuit open (B1303)
- B1304 — Accessory delay relay coil shorted to battery voltage (B1304...
- B1305 — Accessory delay relay coil shorted to ground (B1305)
- B1306 — Oil level switch circuit open (B1306)
- B1307 — Oil level switch circuit shorted to battery voltage (B1307)
- B1308 — Oil level switch circuit shorted to ground (B1308)
- B1309 — Power door lock circuit shorted to ground (B1309)
- B1310 — Power door unlock circuit failure (B1310)
- B1311 — Power door unlock circuit open (B1311)