B2104 — Passenger door key cylinder switch fault
| Meaning | The control unit has found a problem in the switch that signals when the key is turned in the passenger door lock. B2104 is manufacturer-defined, so the exact meaning can vary by make, but the reference points to this switch. |
| Family | Body (B) |
Typical symptoms
The other doors do not follow when you use the key on that side
The alarm does not arm, or arms oddly
Passenger door locking or unlocking intermittently
No symptom, only the stored code
Common causes
Connector or wiring in the door damaged by repeated opening and closing
Moisture or corrosion in the lock
Faulty lock mechanism
Faulty door or comfort control unit
What to do
How to read code B2104
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code B2104 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code B2104 mean?
Passenger door key cylinder switch fault. The control unit has found a problem in the switch that signals when the key is turned in the passenger door lock. B2104 is manufacturer-defined, so the exact meaning can vary by make, but the reference points to this switch.
Can I keep driving with code B2104 active?
With caution: limp mode possible, have it checked soon
Common causes — B2104
Worn or dirty switch in the lock cylinder Connector or wiring in the door damaged by repeated opening and closing Moisture or corrosion in the lock Faulty lock mechanism Faulty door or comfort control unit
How do you fix code B2104?
Try the key on the passenger door and see whether central locking always responds. Check the wiring in the flexible section between door and pillar, where wires most often wear out. It is not urgent, but it can leave you with a door that does not lock properly.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: B2103 — Antenna not connected or antenna signal missing
- Next code: B2105 — Throttle position input too low (definition to be...
Related codes
- B2100 — Driver door key cylinder switch fault
- B2101 — Head restraint switch circuit fault
- B2102 — Antenna circuit short to ground
- B2103 — Antenna not connected or antenna signal missing
- B2105 — Throttle position input too low (definition to be confirmed)
- B2106 — Throttle position input too high (definition to be confirmed...
- B2107 — Front wiper motor relay circuit shorted to battery positive
- B2108 — Trunk key cylinder switch fault
- B2109 — Heated windshield relay circuit shorted to battery positive
- B2110 — Front wiper motor relay circuit open
- B2111 — Door lock input shorted to ground
- B2112 — Driver side memory set switch stuck