B2210 — Interior lamp override switch: short to ground
| Meaning | The control unit detects that the interior lamp override switch circuit is in contact with ground, as if the switch were held pressed all the time. Code B2210 is manufacturer-defined and I can't be certain of the exact operation on every make. It is usually a stuck switch or a wire touching the bodywork. |
| Family | Body (B) |
Typical symptoms
Interior light switch seeming not to respond
Battery draining while parked
Lights not reacting to door opening
Inconsistent behaviour of the cabin lights
Common causes
Wire with damaged insulation touching ground
Wet or dirty connector
Wiring crushed or pinched
Water ingress near the switch
Failure of the module that controls the lights
What to do
How to read code B2210
This is an informational entry: it normally does not limit how the vehicle works.
The code B2210 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code B2210 mean?
Interior lamp override switch: short to ground. The control unit detects that the interior lamp override switch circuit is in contact with ground, as if the switch were held pressed all the time. Code B2210 is manufacturer-defined and I can't be certain of the exact operation on every make. It is usually a stuck switch or a wire touching the bodywork.
Can I keep driving with code B2210 active?
With caution: limp mode possible, have it checked soon
Common causes — B2210
Stuck or faulty switch Wire with damaged insulation touching ground Wet or dirty connector Wiring crushed or pinched Water ingress near the switch Failure of the module that controls the lights
How do you fix code B2210?
Check the switch and nearby wiring, looking for damaged wires or signs of moisture. It is not urgent for driving, but lights that stay on can drain the battery: if you notice it going flat, have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: B2209 — Interior lamp override switch: open circuit
- Next code: B2211 — Low coolant lamp circuit: short to battery
Related codes
- B2200 — No communication with the TV module
- B2201 — No communication with the TrafficMaster module
- B2202 — No communication with the VICS module
- B2203 — Navigation CD-ROM drive fault
- B2204 — GPS antenna circuit open or shorted
- B2205 — GPS receiver fault
- B2206 — Navigation gyroscope fault
- B2207 — Control unit ROM checksum error
- B2208 — Display and switch module communication error
- B2209 — Interior lamp override switch: open circuit
- B2211 — Low coolant lamp circuit: short to battery
- B2214 — Front passenger window: up switch short to battery