Skip to content
Fault code dictionary (DTC)

P030C — Ignition A control signal circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit measured a higher voltage than expected on the control circuit of ignition "A". The letter A is assigned by the manufacturer and can indicate a cylinder, a coil or a group. It can come from a short to power supply, a faulty wire, or a failure of the module or control unit.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Jerky or uneven engine running
Misfires
Loss of power
Possible difficulty starting

Common causes

Control wire touching the power supply
Faulty ignition coil or module
Damaged connector or bent pins
Wiring ruined by heat or chafing
Failed driver stage in the control unit

What to do

Have the wiring and connectors of ignition A checked for bare wires or wrong contacts, then the coil or module. Avoid using the car for long if it runs badly: the catalytic converter can be damaged.

How to read code P030C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P030C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (0C) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P030C mean?

Ignition A control signal circuit high. The control unit measured a higher voltage than expected on the control circuit of ignition "A". The letter A is assigned by the manufacturer and can indicate a cylinder, a coil or a group. It can come from a short to power supply, a faulty wire, or a failure of the module or control unit.

Can I keep driving with code P030C active?

With caution: limp mode possible, have it checked soon

Common causes — P030C

Control wire touching the power supply Faulty ignition coil or module Damaged connector or bent pins Wiring ruined by heat or chafing Failed driver stage in the control unit

How do you fix code P030C?

Have the wiring and connectors of ignition A checked for bare wires or wrong contacts, then the coil or module. Avoid using the car for long if it runs badly: the catalytic converter can be damaged.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes