Skip to content
Fault code dictionary (DTC)

P0379 — Timing reference signal B: no pulses

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer receives no pulses at all from timing reference signal "B" while the engine should be turning. Without this signal it doesn't know where the engine is and often won't allow it to start. The cause can be the sensor, the wiring or the engine's drive mechanism.
FamilyPowertrain (P)

Typical symptoms

Engine cranks but won't start
Check engine light on
Sudden stalling while driving
Rev counter not moving while cranking
No start

Common causes

Faulty crankshaft or camshaft sensor
Broken wiring or disconnected connector
No power or ground at the sensor
Broken or shifted reluctor wheel
Broken or jumped timing belt or chain
Faulty engine control unit (rare)

What to do

Check the sensor connector and wiring right away. If the car won't start or suddenly died, don't keep cranking it: if you suspect the timing drive, another attempt can cause serious damage.

How to read code P0379

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0379 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (79) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0379 mean?

Timing reference signal B: no pulses. The engine computer receives no pulses at all from timing reference signal "B" while the engine should be turning. Without this signal it doesn't know where the engine is and often won't allow it to start. The cause can be the sensor, the wiring or the engine's drive mechanism.

Can I keep driving with code P0379 active?

With caution: limp mode possible, have it checked soon

Common causes — P0379

Faulty crankshaft or camshaft sensor Broken wiring or disconnected connector No power or ground at the sensor Broken or shifted reluctor wheel Broken or jumped timing belt or chain Faulty engine control unit (rare)

How do you fix code P0379?

Check the sensor connector and wiring right away. If the car won't start or suddenly died, don't keep cranking it: if you suspect the timing drive, another attempt can cause serious damage.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes