P037B — Glow plug lamp: control circuit voltage too high
| Meaning | The control unit drives the glow plug warning lamp on the dashboard and has read a higher voltage than expected on the control wire. The fault is in the lamp circuit, not necessarily in the glow plugs themselves. The unit can no longer drive the lamp correctly. |
| Family | Powertrain (P) |
Typical symptoms
Check engine light on
Longer than normal cold starts
White smoke or rough running in the first minutes when cold
No obvious symptom besides the lamp
Common causes
Corroded or loose connector at the instrument cluster or control unit
Fault inside the instrument cluster
Fault in the control unit or glow plug module
Damaged or badly repaired wiring
What to do
How to read code P037B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P037B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (7B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P037B mean?
Glow plug lamp: control circuit voltage too high. The control unit drives the glow plug warning lamp on the dashboard and has read a higher voltage than expected on the control wire. The fault is in the lamp circuit, not necessarily in the glow plugs themselves. The unit can no longer drive the lamp correctly.
Can I keep driving with code P037B active?
With caution: limp mode possible, have it checked soon
Common causes — P037B
Lamp control wire touching a positive supply Corroded or loose connector at the instrument cluster or control unit Fault inside the instrument cluster Fault in the control unit or glow plug module Damaged or badly repaired wiring
How do you fix code P037B?
First check the connectors and the wiring between the control unit and the instrument cluster, then verify that the glow plugs actually work. It is not an immediate emergency, but cold starts can get worse in winter, so do not put it off for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P037A — Glow plug indicator control circuit: low
- Next code: P037C — Cold start camshaft profile system: performance pr...
Related codes
- P0300 — Random/multiple cylinder misfire
- P0301 — Cylinder 1 misfire
- P0302 — Cylinder 2 Misfire Detected
- P0303 — Cylinder 3 Misfire Detected
- P0304 — Cylinder 4 Misfire Detected
- P0305 — Cylinder 5 misfire detected
- P0306 — Cylinder 6 misfire detected
- P0307 — Cylinder 7 misfire detected
- P0308 — Cylinder 8 misfire detected
- P0309 — Cylinder 9 misfire detected
- P030A — Ignition A control signal circuit open
- P030B — Ignition A control signal circuit low