Skip to content
Fault code dictionary (DTC)

P037E — Glow plug sense circuit: signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningIn the circuit that monitors the glow plugs, the control unit read a lower voltage than expected. This can be a short to ground or too much resistance in the wiring. The unit cannot properly verify the glow plugs.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Abnormal glow plug lamp behaviour
Hard cold starting
White smoke when cold
Uneven idle in the first minutes

Common causes

Sense wire shorted to ground
Corroded connector or broken wire
Shorted or damaged glow plug
Faulty glow plug module
Weak battery or poor supply
Fault in the control unit

What to do

Inspect the glow plug wiring and connectors for chafing, moisture or corrosion. Then check the battery and grounds. Do not leave it for months, especially before winter.

How to read code P037E

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P037E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (7E) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P037E mean?

Glow plug sense circuit: signal too low. In the circuit that monitors the glow plugs, the control unit read a lower voltage than expected. This can be a short to ground or too much resistance in the wiring. The unit cannot properly verify the glow plugs.

Can I keep driving with code P037E active?

With caution: limp mode possible, have it checked soon

Common causes — P037E

Sense wire shorted to ground Corroded connector or broken wire Shorted or damaged glow plug Faulty glow plug module Weak battery or poor supply Fault in the control unit

How do you fix code P037E?

Inspect the glow plug wiring and connectors for chafing, moisture or corrosion. Then check the battery and grounds. Do not leave it for months, especially before winter.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes