Skip to content
Fault code dictionary (DTC)

P037F — Glow plug sense circuit: signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningIn the circuit that monitors the glow plugs, the control unit read a higher voltage than expected. This can be a contact with a positive supply or an open circuit. The glow plug check cannot be trusted.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Glow plug lamp on or off abnormally
Longer cold starts
White smoke at start-up
Normal running once warm

Common causes

Sense wire touching a positive supply
Open circuit from an unplugged connector or broken wire
Glow plugs with out-of-range resistance
Faulty glow plug module
Fault in the control unit

What to do

Check connectors and wiring, looking for disconnected or damaged wires. Then have the glow plugs and the module tested. The problem shows more in cold weather, so it is best not to postpone it.

How to read code P037F

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P037F starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (3) points to ignition system or misfire, and the last two (7F) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P037F mean?

Glow plug sense circuit: signal too high. In the circuit that monitors the glow plugs, the control unit read a higher voltage than expected. This can be a contact with a positive supply or an open circuit. The glow plug check cannot be trusted.

Can I keep driving with code P037F active?

With caution: limp mode possible, have it checked soon

Common causes — P037F

Sense wire touching a positive supply Open circuit from an unplugged connector or broken wire Glow plugs with out-of-range resistance Faulty glow plug module Fault in the control unit

How do you fix code P037F?

Check connectors and wiring, looking for disconnected or damaged wires. Then have the glow plugs and the module tested. The problem shows more in cold weather, so it is best not to postpone it.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes