Skip to content
Fault code dictionary (DTC)

P060D — Internal control module accelerator pedal check fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit cross-checks the accelerator pedal signals internally to be sure it reads them correctly, and it found an inconsistency or an error in its own check. This is a safety check: if it is not sure what you want from the pedal, it limits power.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Limited power or forced idle
Delayed or no response to the accelerator
Cruise control disabled
Jerky acceleration

Common causes

Faulty accelerator pedal sensor
Corroded pedal wiring or connector
Disturbed sensor reference voltage
Control unit software needing an update
Internal failure of the control unit

What to do

Have the pedal sensor, connector and wiring checked first, then the sensor supply. Because it affects throttle response, it is a safety issue: if the response is uncertain, do not drive.

How to read code P060D

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P060D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (0D) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P060D mean?

Internal control module accelerator pedal check fault. The control unit cross-checks the accelerator pedal signals internally to be sure it reads them correctly, and it found an inconsistency or an error in its own check. This is a safety check: if it is not sure what you want from the pedal, it limits power.

Can I keep driving with code P060D active?

With caution: limp mode possible, have it checked soon

Common causes — P060D

Faulty accelerator pedal sensor Corroded pedal wiring or connector Disturbed sensor reference voltage Control unit software needing an update Internal failure of the control unit

How do you fix code P060D?

Have the pedal sensor, connector and wiring checked first, then the sensor supply. Because it affects throttle response, it is a safety issue: if the response is uncertain, do not drive.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes