P06EF — Engine restart performance fault (Stop-Start)
| Meaning | The control unit detected that the engine did not restart as expected after an automatic shutdown, for example after a stop with a Stop-Start system. The restart was too slow, failed or needed more than one attempt. |
| Family | Powertrain (P) |
Typical symptoms
Jerky or shaky restart
Stop-Start system deactivates by itself
Check engine light or Stop-Start light on
Sometimes the engine stays off
Common causes
Worn starter motor
Cables or grounds with poor contact
Faulty crankshaft or camshaft position sensor
Problem in the Stop-Start control logic
What to do
How to read code P06EF
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06EF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (EF) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06EF mean?
Engine restart performance fault (Stop-Start). The control unit detected that the engine did not restart as expected after an automatic shutdown, for example after a stop with a Stop-Start system. The restart was too slow, failed or needed more than one attempt.
Can I keep driving with code P06EF active?
With caution: limp mode possible, have it checked soon
Common causes — P06EF
Weak battery or one unsuited to Stop-Start use Worn starter motor Cables or grounds with poor contact Faulty crankshaft or camshaft position sensor Problem in the Stop-Start control logic
How do you fix code P06EF?
Have the battery checked first, since on Stop-Start systems it is the most common cause. If the engine stalls in traffic or at lights it is a safety risk: have it looked at soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06EE — Engine RPM output signal circuit high
- Next code: P06F0 — AdBlue control module internal temperature sensor...
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault