Skip to content
Fault code dictionary (DTC)

P06F0 — AdBlue control module internal temperature sensor circuit

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit that manages the AdBlue (reductant) system detected a problem in the circuit of the sensor that measures its own internal temperature. Without this data the module cannot protect itself from overheating or dose correctly.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Warning about the AdBlue or emissions system
Possible reduction in power
Possible start limitation if the fault persists
Higher than normal emissions

Common causes

Internal fault in the AdBlue control module
Damaged wiring or connector
Moisture or corrosion at the contacts
Module overheating from exhaust heat
Power supply or ground problem at the module

What to do

Have the module connectors and wiring checked and the data read with a diagnostic tool. Don't put it off too long: on AdBlue systems a persistent fault can lead to restrictions.

How to read code P06F0

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P06F0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (F0) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P06F0 mean?

AdBlue control module internal temperature sensor circuit. The control unit that manages the AdBlue (reductant) system detected a problem in the circuit of the sensor that measures its own internal temperature. Without this data the module cannot protect itself from overheating or dose correctly.

Can I keep driving with code P06F0 active?

With caution: limp mode possible, have it checked soon

Common causes — P06F0

Internal fault in the AdBlue control module Damaged wiring or connector Moisture or corrosion at the contacts Module overheating from exhaust heat Power supply or ground problem at the module

How do you fix code P06F0?

Have the module connectors and wiring checked and the data read with a diagnostic tool. Don't put it off too long: on AdBlue systems a persistent fault can lead to restrictions.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes