P06F6 — Glow plug control module 2 control circuit open
| Meaning | The control unit detected that the control circuit of the second glow plug module is open or not responding. The module may therefore not receive the command to switch the glow plugs on. |
| Family | Powertrain (P) |
Typical symptoms
White or gray smoke at start-up
Rough running in the first minutes
Glow plug light or check engine light on
Normal operation when warm
Common causes
Corroded contacts
Internal fault in the glow plug module
Faulty fuse or power relay
Fault in the engine control unit
What to do
How to read code P06F6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06F6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (F6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06F6 mean?
Glow plug control module 2 control circuit open. The control unit detected that the control circuit of the second glow plug module is open or not responding. The module may therefore not receive the command to switch the glow plugs on.
Can I keep driving with code P06F6 active?
With caution: limp mode possible, have it checked soon
Common causes — P06F6
Broken control wire or disconnected connector Corroded contacts Internal fault in the glow plug module Faulty fuse or power relay Fault in the engine control unit
How do you fix code P06F6?
Have the connectors and the continuity of the control wire between the control unit and the module checked. The problem shows more in cold weather, so it is best not to put it off.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06F5 — Glow plug control module 2 fault
- Next code: P06F7 — Glow plug control module 2 control circuit low
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault