P06F7 — Glow plug control module 2 control circuit low
| Meaning | The control unit detected that the voltage on the control circuit of the second glow plug module is too low, often because of a grounded wire or a module fault. Preheating may therefore not work correctly. |
| Family | Powertrain (P) |
Typical symptoms
White or gray smoke at start-up
Rough running in the first minutes
Glow plug light or check engine light on
Possible lack of preheating
Common causes
Wiring with damaged insulation
Internal fault in the glow plug module
Connector with moisture ingress
Fault in the engine control unit
What to do
How to read code P06F7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06F7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (F7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06F7 mean?
Glow plug control module 2 control circuit low. The control unit detected that the voltage on the control circuit of the second glow plug module is too low, often because of a grounded wire or a module fault. Preheating may therefore not work correctly.
Can I keep driving with code P06F7 active?
With caution: limp mode possible, have it checked soon
Common causes — P06F7
Control wire shorted to ground Wiring with damaged insulation Internal fault in the glow plug module Connector with moisture ingress Fault in the engine control unit
How do you fix code P06F7?
Have the control circuit wiring checked, looking for chafed or crushed spots. If the car starts poorly when cold, acting soon avoids unnecessary strain on the engine and battery.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06F6 — Glow plug control module 2 control circuit open
- Next code: P06F8 — Glow plug control module 2 control circuit high
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault