P06F8 — Glow plug control module 2 control circuit high
| Meaning | The control unit detected that the voltage on the control circuit of the second glow plug module is too high, often because of a short to the power supply or a module fault. The glow plugs may stay on or not be controlled properly. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting when cold
White or gray smoke at start-up
Glow plugs that seem to stay active too long
Rough running in the first minutes
Common causes
Damaged wiring or corroded connector
Internal fault in the glow plug module
Relay or supply that stays active
Fault in the engine control unit
What to do
How to read code P06F8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06F8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (F8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06F8 mean?
Glow plug control module 2 control circuit high. The control unit detected that the voltage on the control circuit of the second glow plug module is too high, often because of a short to the power supply or a module fault. The glow plugs may stay on or not be controlled properly.
Can I keep driving with code P06F8 active?
With caution: limp mode possible, have it checked soon
Common causes — P06F8
Control wire shorted to the power supply Damaged wiring or corroded connector Internal fault in the glow plug module Relay or supply that stays active Fault in the engine control unit
How do you fix code P06F8?
Have the control circuit wiring and connectors and the module operation checked. If the glow plugs stay powered too long they can be damaged, so it is not wise to wait.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06F7 — Glow plug control module 2 control circuit low
- Next code: P06F9 — Glow plug control module 2 system voltage out of r...
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault