P06FA — Glow plug control module 2 performance fault
| Meaning | The control unit detected that the second glow plug module is not working as expected, for example not delivering the expected current or not responding to commands in time. The module responds, but its behavior is out of range. |
| Family | Powertrain (P) |
Typical symptoms
White or gray smoke at start-up
Rough running in the first minutes
Glow plug light or check engine light on
More noise and vibration when cold
Common causes
Glow plug module with internal fault
Insufficient power supply or grounds
Wiring or connectors in poor condition
Communication problem with the engine control unit
What to do
How to read code P06FA
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06FA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (FA) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06FA mean?
Glow plug control module 2 performance fault. The control unit detected that the second glow plug module is not working as expected, for example not delivering the expected current or not responding to commands in time. The module responds, but its behavior is out of range.
Can I keep driving with code P06FA active?
With caution: limp mode possible, have it checked soon
Common causes — P06FA
Worn glow plugs drawing too much or too little current Glow plug module with internal fault Insufficient power supply or grounds Wiring or connectors in poor condition Communication problem with the engine control unit
How do you fix code P06FA?
Have the condition of the glow plugs and the operation of the module checked with a diagnostic tool. The problem gets worse in the cold, so it is best to act before winter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06F9 — Glow plug control module 2 system voltage out of r...
- Next code: P06FB — Glow plug control module 2 memory checksum error
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault