P06FB — Glow plug control module 2 memory checksum error
| Meaning | The second glow plug module detected an error in the check of its own memory (checksum): the data stored inside it is not correct. It is an internal fault of the module's electronics. |
| Family | Powertrain (P) |
Typical symptoms
Hard starting when cold
Irregular or absent preheating
White or gray smoke at start-up
Other codes related to the module
Common causes
Voltage drop or electrical noise while saving data
Module software needing an update or reprogramming
Irregular power supply or grounds
Moisture or heat damage to the electronics
What to do
How to read code P06FB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P06FB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (FB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P06FB mean?
Glow plug control module 2 memory checksum error. The second glow plug module detected an error in the check of its own memory (checksum): the data stored inside it is not correct. It is an internal fault of the module's electronics.
Can I keep driving with code P06FB active?
With caution: limp mode possible, have it checked soon
Common causes — P06FB
Internal fault in the glow plug module Voltage drop or electrical noise while saving data Module software needing an update or reprogramming Irregular power supply or grounds Moisture or heat damage to the electronics
How do you fix code P06FB?
First check the module's power supply and grounds; if the problem remains, the module needs to be diagnosed and is usually replaced or reprogrammed. Starting may get worse in the cold, so don't put it off too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P06FA — Glow plug control module 2 performance fault
- Next code: P06FC — Glow plug control module 2 to engine control unit...
Related codes
- P0600 — Serial communication link malfunction
- P0601 — Internal Control Module Memory Check Sum Error
- P0602 — Control module programming error
- P0603 — Internal Control Module Keep Alive Memory (KAM) Error
- P0604 — Internal control module RAM error
- P0605 — Internal Control Module Read Only Memory (ROM) Error
- P0606 — Control module processor fault
- P0607 — Control module performance out of range
- P0608 — Control module speed signal output A malfunction
- P0609 — Control module speed signal output B malfunction
- P060A — Internal control module monitoring processor fault
- P060B — Internal control module A/D conversion fault