P0D47 — Charger 14 V output current sensor circuit fault
| Meaning | The control unit detected a fault in the circuit of the sensor that measures the charger's 14-volt output current. This current charges and supplies the car's 12-volt system. Without a reliable reading, management of the 12-volt battery may be imprecise. |
| Family | Powertrain (P) |
Typical symptoms
Battery or charging system warning light
12-volt battery that goes flat faster
System start-up sometimes difficult
Electrical accessories behaving abnormally
Common causes
Faulty current sensor
Old or weak 12-volt battery
Incorrect sensor supply or ground
Internal fault in the converter or charger
What to do
How to read code P0D47
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D47 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D47 mean?
Charger 14 V output current sensor circuit fault. The control unit detected a fault in the circuit of the sensor that measures the charger's 14-volt output current. This current charges and supplies the car's 12-volt system. Without a reliable reading, management of the 12-volt battery may be imprecise.
Can I keep driving with code P0D47 active?
With caution: limp mode possible, have it checked soon
Common causes — P0D47
Damaged current sensor wiring or connector Faulty current sensor Old or weak 12-volt battery Incorrect sensor supply or ground Internal fault in the converter or charger
How do you fix code P0D47?
First have the 12-volt battery and its terminals checked, because a weak battery complicates diagnosis. If other warning lights appear or the car struggles to start, do not put it off. The converter should be examined at a workshop approved for high-voltage vehicles.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D46 — Charger 14 V output voltage sensor: unstable signa...
- Next code: P0D48 — Charger 14 V output current sensor: implausible re...
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range