P0D49 — Charger 14 V output current sensor: signal too low
| Meaning | The control unit read a signal from the 14-volt output current sensor lower than the expected minimum. It may be an electrical fault in the sensor circuit or an output that is not delivering the current required. This can leave the 12-volt battery poorly charged. |
| Family | Powertrain (P) |
Typical symptoms
Battery warning light on
12-volt battery going flat
Weaker lights and accessories
Difficulty starting the system
Common causes
Corroded or loose connector
Faulty current sensor
Fuse or connection of the 14 V output in poor condition
Converter not delivering the required current
What to do
How to read code P0D49
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D49 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D49 mean?
Charger 14 V output current sensor: signal too low. The control unit read a signal from the 14-volt output current sensor lower than the expected minimum. It may be an electrical fault in the sensor circuit or an output that is not delivering the current required. This can leave the 12-volt battery poorly charged.
Can I keep driving with code P0D49 active?
With caution: limp mode possible, have it checked soon
Common causes — P0D49
Sensor wire shorted to ground or broken Corroded or loose connector Faulty current sensor Fuse or connection of the 14 V output in poor condition Converter not delivering the required current
How do you fix code P0D49?
Have the 12-volt battery and terminals checked right away. If the car starts with difficulty or other warning lights appear, go to a workshop without waiting so you do not lose power while driving. Diagnosis of the converter belongs to staff approved for high-voltage vehicles.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D48 — Charger 14 V output current sensor: implausible re...
- Next code: P0D4A — Charger 14 V output current sensor: signal too hig...
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range