P0D80 — Battery charger input circuit open
| Meaning | The onboard battery charger control module, which converts power from the outlet into energy for the traction battery, has detected an open input circuit. In practice, power is not arriving, or the connection between the socket, cable and charger is not continuous. Charging may not start or may stop. Exact details vary by manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Charging that stops after a short time
Fault or charging warning light on
Charging error message on the dashboard
Charging only works with some stations or outlets
Common causes
Faulty charging cable or charging station
Loose onboard charger connector
Broken input wiring
Charging circuit fuse or protection tripped
Internal fault in the onboard charger
What to do
How to read code P0D80
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D80 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D80 mean?
Battery charger input circuit open. The onboard battery charger control module, which converts power from the outlet into energy for the traction battery, has detected an open input circuit. In practice, power is not arriving, or the connection between the socket, cable and charger is not continuous. Charging may not start or may stop. Exact details vary by manufacturer.
Can I keep driving with code P0D80 active?
With caution: limp mode possible, have it checked soon
Common causes — P0D80
Vehicle charging inlet with dirty or damaged contacts Faulty charging cable or charging station Loose onboard charger connector Broken input wiring Charging circuit fuse or protection tripped Internal fault in the onboard charger
How do you fix code P0D80?
First try another cable and another station or outlet, and check that the contacts of the vehicle inlet are clean and dry. If the problem stays, have the car checked: the circuit is high-voltage and must be opened only by qualified technicians. The car can usually be driven, but without charging you may be left with low range.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D7F — A/C compressor motor phase W current too high
- Next code: P0D81 — Battery charger input out of expected range
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range