Skip to content
Fault code dictionary (DTC)

P0D82 — Battery charger input signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe onboard battery charger control module has measured a lower than normal voltage or signal on the input circuit. It can come from weak mains supply, a short to ground, a high-resistance contact, or a charger fault. Charging may be reduced or blocked. Details vary by manufacturer.
FamilyPowertrain (P)

Typical symptoms

Charging does not start, or starts and stops
Very slow charging
Fault or charging warning light on
Charging error message on the dashboard
Problem more frequent with certain outlets or stations

Common causes

Low mains voltage or overloaded household circuit
Unsuitable or overly long extension cord or cable
Vehicle inlet contacts dirty, wet or scorched
Input wiring shorted to ground
Connector with abnormal resistance
Internal fault in the onboard charger

What to do

Avoid extension cords and try another outlet or station. Look for signs of moisture or overheating on the vehicle inlet. If you see burn marks or the problem stays, stop charging that way and have the car checked.

How to read code P0D82

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0D82 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0D82 mean?

Battery charger input signal too low. The onboard battery charger control module has measured a lower than normal voltage or signal on the input circuit. It can come from weak mains supply, a short to ground, a high-resistance contact, or a charger fault. Charging may be reduced or blocked. Details vary by manufacturer.

Can I keep driving with code P0D82 active?

With caution: limp mode possible, have it checked soon

Common causes — P0D82

Low mains voltage or overloaded household circuit Unsuitable or overly long extension cord or cable Vehicle inlet contacts dirty, wet or scorched Input wiring shorted to ground Connector with abnormal resistance Internal fault in the onboard charger

How do you fix code P0D82?

Avoid extension cords and try another outlet or station. Look for signs of moisture or overheating on the vehicle inlet. If you see burn marks or the problem stays, stop charging that way and have the car checked.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes