P0D85 — Battery charger output voltage too high
| Meaning | The control module has detected that the voltage the onboard charger sends to the traction battery is higher than the allowed limit. The system treats this as serious, because excess voltage can damage the battery. Charging is usually stopped immediately for protection. The cause may be in the charger, its control, or the voltage reading. |
| Family | Powertrain (P) |
Typical symptoms
Charging does not start
Fault or charging warning light on
Charging error message on the dashboard
Possible power limitation or other warnings from the high-voltage system
Common causes
Inaccurate or faulty output voltage sensor
Communication problem between charger and battery management
Battery management system fault
Damaged output wiring or connectors
Outdated charger or battery management software
What to do
How to read code P0D85
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D85 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D85 mean?
Battery charger output voltage too high. The control module has detected that the voltage the onboard charger sends to the traction battery is higher than the allowed limit. The system treats this as serious, because excess voltage can damage the battery. Charging is usually stopped immediately for protection. The cause may be in the charger, its control, or the voltage reading.
Can I keep driving with code P0D85 active?
With caution: limp mode possible, have it checked soon
Common causes — P0D85
Fault in the onboard charger control Inaccurate or faulty output voltage sensor Communication problem between charger and battery management Battery management system fault Damaged output wiring or connectors Outdated charger or battery management software
How do you fix code P0D85?
Do not keep trying to charge, and do not use the vehicle if other high-voltage system warnings appear. Take the car to a workshop qualified on electric or hybrid vehicles for diagnosis. It should be treated carefully, because it involves the battery.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D84 — Battery charger input signal erratic
- Next code: P0D86 — Charge coupler status indicator circuit A open
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range