P0D87 — Charge coupler status indicator circuit A low
| Meaning | The control module drives the charging connector's status indicator, such as a light, through a circuit called A. It has detected a lower than normal voltage on this circuit, typical of a short to ground or a fault in the driver. The code is standard, but which indicator is circuit A depends on the manufacturer. Charging may work, but the indicator may not behave properly. |
| Family | Powertrain (P) |
Typical symptoms
Wrong charging status indication
Fault warning light on
Charging error message on some models
Charging that sometimes does not start or gets stuck
Common causes
Indicator lamp or LED shorted
Moisture in the connector or charging inlet
Fault in the module driving the indicator
Pinched wiring or worn insulation
Damaged connector
What to do
How to read code P0D87
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D87 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D87 mean?
Charge coupler status indicator circuit A low. The control module drives the charging connector's status indicator, such as a light, through a circuit called A. It has detected a lower than normal voltage on this circuit, typical of a short to ground or a fault in the driver. The code is standard, but which indicator is circuit A depends on the manufacturer. Charging may work, but the indicator may not behave properly.
Can I keep driving with code P0D87 active?
With caution: limp mode possible, have it checked soon
Common causes — P0D87
Indicator circuit wire shorted to ground Indicator lamp or LED shorted Moisture in the connector or charging inlet Fault in the module driving the indicator Pinched wiring or worn insulation Damaged connector
How do you fix code P0D87?
Check the charging inlet for moisture, dirt or damage, then have the indicator circuit tested with a diagnostic tool. If charging works you can use the car, but don't put off the check for too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D86 — Charge coupler status indicator circuit A open
- Next code: P0D88 — Charge coupler status indicator circuit A high
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range