P0DF0 — Generator inverter temperature sensor B circuit fault
| Meaning | The control unit found an electrical fault in the circuit of temperature sensor B of the generator inverter. The inverter is the power electronics that run the generator in hybrid cars, and its temperature is monitored to prevent overheating. The code is standard, but which physical sensor is called B depends on the manufacturer, and I can't tell you that with certainty. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or limp mode
Combustion engine stays on longer than normal
Hybrid battery charging less effective
Error message on the dashboard
Common causes
Faulty temperature sensor
Inverter cooling problem skewing the reading
Faulty internal electronics in the inverter
Irregular sensor power or ground
What to do
How to read code P0DF0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0DF0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0DF0 mean?
Generator inverter temperature sensor B circuit fault. The control unit found an electrical fault in the circuit of temperature sensor B of the generator inverter. The inverter is the power electronics that run the generator in hybrid cars, and its temperature is monitored to prevent overheating. The code is standard, but which physical sensor is called B depends on the manufacturer, and I can't tell you that with certainty.
Can I keep driving with code P0DF0 active?
With caution: limp mode possible, have it checked soon
Common causes — P0DF0
Damaged or corroded sensor connector or wiring Faulty temperature sensor Inverter cooling problem skewing the reading Faulty internal electronics in the inverter Irregular sensor power or ground
How do you fix code P0DF0?
Have the live data read to see whether the inverter temperature is plausible, and check the sensor connectors and wiring. If the car goes into reduced power, stop as soon as it is safe to do so, because the inverter contains high-voltage parts that only qualified staff should handle.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0DEF — Pedestrian alert module circuit signal too high
- Next code: P0DF1 — Generator inverter temperature sensor B unstable s...
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range