B1611 — Rear wiper mode select switch circuit failure
| Meaning | The control module detected a fault in the circuit of the switch that selects the rear wiper mode (for example intermittent or continuous), without specifying the type of fault. This code is manufacturer-defined: the wording matches Ford-type vehicles, and for other brands I have no reliable detail. The switch is not being read correctly. |
| Family | Body (B) |
Typical symptoms
Rear wiper does not start or starts by itself
Works only in some switch positions
Rear washer may not respond
Sometimes no obvious symptom
Common causes
Damaged wiring, especially in the tailgate passage
Connector with moisture or corrosion
Fault in the module that controls the rear wiper
Circuit power supply problem
What to do
How to read code B1611
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code B1611 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code B1611 mean?
Rear wiper mode select switch circuit failure. The control module detected a fault in the circuit of the switch that selects the rear wiper mode (for example intermittent or continuous), without specifying the type of fault. This code is manufacturer-defined: the wording matches Ford-type vehicles, and for other brands I have no reliable detail. The switch is not being read correctly.
Can I keep driving with code B1611 active?
With caution: limp mode possible, have it checked soon
Common causes — B1611
Worn or dirty wiper stalk or switch Damaged wiring, especially in the tailgate passage Connector with moisture or corrosion Fault in the module that controls the rear wiper Circuit power supply problem
How do you fix code B1611?
Try the rear wiper in every position and note which ones do not respond. Then have the switch, connectors and wiring checked, especially towards the tailgate. It is not urgent, but rear visibility can be reduced in rain.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: B1610 — Illuminated entry input shorted to ground
- Next code: B1612 — Rear wiper mode select switch circuit open
Related codes
- B1600 — PATS anti-theft: no signal from ignition key transponder
- B1601 — PATS anti-theft: incorrect key code from ignition transponde...
- B1602 — PATS anti-theft: invalid key code format from transponder
- B1603 — Anti-theft indicator lamp circuit failure
- B1604 — Anti-theft indicator lamp circuit open
- B1605 — Anti-theft indicator lamp circuit shorted to battery
- B1606 — Anti-theft indicator lamp circuit shorted to ground
- B1607 — Illuminated entry input circuit failure
- B1608 — Illuminated entry input circuit open
- B1609 — Illuminated entry input shorted to battery
- B1610 — Illuminated entry input shorted to ground
- B1612 — Rear wiper mode select switch circuit open