Skip to content
Fault code dictionary (DTC)

P0002 — Fuel volume regulator performance out of range

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit has detected that the fuel volume regulator, the valve that meters how much fuel enters the high-pressure pump, isn't behaving as commanded. Fuel pressure isn't following the requested value. The electrical circuit may be fine, with the problem being mechanical or hydraulic.
FamilyPowertrain (P)

Typical symptoms

Engine losing power
Hard or slow starting
Jerking or hesitation when accelerating
Check engine light on
Engine stalling at low speed

Common causes

Dirty or worn regulator or metering valve
Clogged fuel filter
Weak feed pump
Worn high-pressure pump
Fuel leaks or air in the fuel circuit
Poor quality fuel

What to do

First check the fuel filter and the low-pressure supply. If power drops, avoid heavy loads and have it checked soon, because a struggling high-pressure pump can get worse.

How to read code P0002

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0002 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (02) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0002 mean?

Fuel volume regulator performance out of range. The control unit has detected that the fuel volume regulator, the valve that meters how much fuel enters the high-pressure pump, isn't behaving as commanded. Fuel pressure isn't following the requested value. The electrical circuit may be fine, with the problem being mechanical or hydraulic.

Can I keep driving with code P0002 active?

With caution: limp mode possible, have it checked soon

Common causes — P0002

Dirty or worn regulator or metering valve Clogged fuel filter Weak feed pump Worn high-pressure pump Fuel leaks or air in the fuel circuit Poor quality fuel

How do you fix code P0002?

First check the fuel filter and the low-pressure supply. If power drops, avoid heavy loads and have it checked soon, because a struggling high-pressure pump can get worse.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes