P0003 — Fuel volume regulator control circuit low
| Meaning | The control unit measured too low a voltage in the circuit that drives the fuel volume regulator. In practice the wire or command seems to be going to ground or not getting the right supply. The regulator can't meter fuel as requested. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Hard or impossible starting
Engine going into limp mode
Rough idle
Common causes
Corroded or loose connector
Regulator with a faulty coil
Pinched or chafed wiring
Internal engine control unit fault
What to do
How to read code P0003
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0003 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (03) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0003 mean?
Fuel volume regulator control circuit low. The control unit measured too low a voltage in the circuit that drives the fuel volume regulator. In practice the wire or command seems to be going to ground or not getting the right supply. The regulator can't meter fuel as requested.
Can I keep driving with code P0003 active?
With caution: limp mode possible, have it checked soon
Common causes — P0003
Wire shorted to ground Corroded or loose connector Regulator with a faulty coil Pinched or chafed wiring Internal engine control unit fault
How do you fix code P0003?
Inspect the regulator connector and wiring, often fitted on the high-pressure pump. If the car starts badly or goes into limp mode, don't keep trying and have the circuit checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0002 — Fuel volume regulator performance out of range
- Next code: P0004 — Fuel volume regulator control circuit high
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2
- P000D — Camshaft B position slow response, bank 2