P0008 — Engine position system performance, bank 1
| Meaning | The control unit compares the crankshaft and camshaft signals to check that the valve timing is correct. On this bank, the camshaft position doesn't match what is expected. It can be a variable timing or a timing drive problem. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Loss of power
Hard starting
Unusual noise from the timing area
Common causes
Faulty variable valve timing solenoid
Stretched or out-of-time timing chain or belt
Faulty camshaft or crankshaft sensor
Worn camshaft phaser
What to do
How to read code P0008
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0008 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (08) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0008 mean?
Engine position system performance, bank 1. The control unit compares the crankshaft and camshaft signals to check that the valve timing is correct. On this bank, the camshaft position doesn't match what is expected. It can be a variable timing or a timing drive problem.
Can I keep driving with code P0008 active?
With caution: limp mode possible, have it checked soon
Common causes — P0008
Dirty, low or unsuitable engine oil Faulty variable valve timing solenoid Stretched or out-of-time timing chain or belt Faulty camshaft or crankshaft sensor Worn camshaft phaser
How do you fix code P0008?
Check the oil level and condition right away. If you hear noise from the timing area, stop and have it checked: incorrect timing can cause serious engine damage.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0007 — Fuel shutoff valve control circuit high
- Next code: P0009 — Engine position system performance, bank 2
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2
- P000D — Camshaft B position slow response, bank 2