P0007 — Fuel shutoff valve control circuit high
| Meaning | The control unit measured too high a voltage in the fuel shutoff valve control. It can come from a short to positive or a problem in the driver circuit. The valve might not open or close when needed. |
| Family | Powertrain (P) |
Typical symptoms
Sudden stalling
Check engine light on
Loss of power
Engine struggling to shut down
Common causes
Faulty valve
Damaged connector
Wiring with damaged insulation
Internal control unit fault
What to do
How to read code P0007
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0007 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (07) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0007 mean?
Fuel shutoff valve control circuit high. The control unit measured too high a voltage in the fuel shutoff valve control. It can come from a short to positive or a problem in the driver circuit. The valve might not open or close when needed.
Can I keep driving with code P0007 active?
With caution: limp mode possible, have it checked soon
Common causes — P0007
Wire shorted to positive Faulty valve Damaged connector Wiring with damaged insulation Internal control unit fault
How do you fix code P0007?
Inspect the valve wiring and connector. If you notice stalling or failure to start, don't delay the check.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0006 — Fuel shutoff valve control circuit low
- Next code: P0008 — Engine position system performance, bank 1
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2
- P000D — Camshaft B position slow response, bank 2