Skip to content
Fault code dictionary (DTC)

P0B00 — Electric transmission fluid pump: phase U current fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit found a problem with the phase U current of the electric pump motor that keeps transmission fluid pressurized. This pump is mainly needed when the combustion engine is off, for example on hybrids and start-stop systems. The code indicates an incorrect current value without saying whether it is too high or too low.
FamilyPowertrain (P)

Typical symptoms

Warning light on
Delay or jerking when the engine restarts
Transmission engaging poorly after a stop
Unusual noise from the pump
Limp mode

Common causes

Pump wiring or connector with a poor contact
Worn pump motor
Faulty pump drive circuit
Low or degraded transmission fluid
Problem in the control unit

What to do

Check the transmission fluid level and condition first, then the pump connections. If you notice jerking or driving difficulty, limit use of the car and have it examined.

How to read code P0B00

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0B00 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (00) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0B00 mean?

Electric transmission fluid pump: phase U current fault. The control unit found a problem with the phase U current of the electric pump motor that keeps transmission fluid pressurized. This pump is mainly needed when the combustion engine is off, for example on hybrids and start-stop systems. The code indicates an incorrect current value without saying whether it is too high or too low.

Can I keep driving with code P0B00 active?

With caution: limp mode possible, have it checked soon

Common causes — P0B00

Pump wiring or connector with a poor contact Worn pump motor Faulty pump drive circuit Low or degraded transmission fluid Problem in the control unit

How do you fix code P0B00?

Check the transmission fluid level and condition first, then the pump connections. If you notice jerking or driving difficulty, limit use of the car and have it examined.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes