Skip to content
Fault code dictionary (DTC)

P0B0C — Auxiliary transmission fluid pump A: hydraulic leakage

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit has detected that the auxiliary transmission fluid pump (pump A) cannot reach the expected pressure, as if oil were escaping from the circuit. It may be a real leak or internal wear in the pump. The code is defined by the standard, but how each manufacturer detects the leak can differ.
FamilyPowertrain (P)

Typical symptoms

Engine or transmission warning light on
Gearbox slow to engage after standing or after an engine stop
Jerks or slipping during gear changes
Oil stains under the car near the gearbox
Electric mode or start&stop limited

Common causes

Seals or lines of the transmission oil circuit leaking
Low transmission oil level
Auxiliary pump worn internally
Hydraulic valve or solenoid that does not hold
Clogged transmission oil filter
Internal wear in the gearbox hydraulic body

What to do

Have the transmission oil level checked straight away and look for signs of a leak. Driving with too little oil in the gearbox can cause serious damage, so avoid long trips until it is clarified.

How to read code P0B0C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0B0C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (0C) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0B0C mean?

Auxiliary transmission fluid pump A: hydraulic leakage. The control unit has detected that the auxiliary transmission fluid pump (pump A) cannot reach the expected pressure, as if oil were escaping from the circuit. It may be a real leak or internal wear in the pump. The code is defined by the standard, but how each manufacturer detects the leak can differ.

Can I keep driving with code P0B0C active?

With caution: limp mode possible, have it checked soon

Common causes — P0B0C

Seals or lines of the transmission oil circuit leaking Low transmission oil level Auxiliary pump worn internally Hydraulic valve or solenoid that does not hold Clogged transmission oil filter Internal wear in the gearbox hydraulic body

How do you fix code P0B0C?

Have the transmission oil level checked straight away and look for signs of a leak. Driving with too little oil in the gearbox can cause serious damage, so avoid long trips until it is clarified.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes