P0B02 — Electric transmission fluid pump: phase U current too high
| Meaning | The control unit measured too much current on phase U of the electric transmission fluid pump motor. Excess current can mean a short circuit or a pump struggling to turn. The system may switch the pump off to avoid damage. |
| Family | Powertrain (P) |
Typical symptoms
Pump stopping or going into protection
Transmission engaging poorly or late
Noise or vibration from the pump
Limp mode
Common causes
Short circuit in the wiring or winding
Very dirty or too thick transmission fluid
Faulty drive circuit
Problem in the control unit
What to do
How to read code P0B02
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0B02 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (02) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0B02 mean?
Electric transmission fluid pump: phase U current too high. The control unit measured too much current on phase U of the electric transmission fluid pump motor. Excess current can mean a short circuit or a pump struggling to turn. The system may switch the pump off to avoid damage.
Can I keep driving with code P0B02 active?
With caution: limp mode possible, have it checked soon
Common causes — P0B02
Pump seized or stiff from wear Short circuit in the wiring or winding Very dirty or too thick transmission fluid Faulty drive circuit Problem in the control unit
How do you fix code P0B02?
Have the transmission fluid, the pump's freedom to turn and the wiring checked. Don't keep using the car if driving becomes uneven.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0B01 — Electric transmission fluid pump: phase U current...
- Next code: P0B03 — Electric transmission fluid pump: phase V current...
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high
- P0B0C — Auxiliary transmission fluid pump A: hydraulic leakage