Skip to content
Fault code dictionary (DTC)

P0B22 — Battery pack voltage sense circuit D intermittent signal

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe voltage signal on channel D comes and goes, or swings irregularly. This is typically a contact problem that shows up with vibration, heat or moisture. That is why the fault can seem to vanish and then return.
FamilyPowertrain (P)

Typical symptoms

Warning light that comes on and goes off
Power loss from time to time
Unstable charge gauge
Occasional error messages
Starting sometimes difficult

Common causes

Connector with intermittent contact
Wiring chafed or broken inside the insulation
Corrosion caused by moisture
Sensor or measurement board losing signal at times
Loose mounting of the control module

What to do

An intermittent fault has to be hunted carefully: flexing the harness while reading live data helps to find it. Have a high-voltage qualified workshop do it. Do not ignore it, because it can get worse and leave you without drive.

How to read code P0B22

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0B22 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (22) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0B22 mean?

Battery pack voltage sense circuit D intermittent signal. The voltage signal on channel D comes and goes, or swings irregularly. This is typically a contact problem that shows up with vibration, heat or moisture. That is why the fault can seem to vanish and then return.

Can I keep driving with code P0B22 active?

With caution: limp mode possible, have it checked soon

Common causes — P0B22

Connector with intermittent contact Wiring chafed or broken inside the insulation Corrosion caused by moisture Sensor or measurement board losing signal at times Loose mounting of the control module

How do you fix code P0B22?

An intermittent fault has to be hunted carefully: flexing the harness while reading live data helps to find it. Have a high-voltage qualified workshop do it. Do not ignore it, because it can get worse and leave you without drive.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes