P0B70 — HV battery voltage sense circuit K: signal too high
| Meaning | The high-voltage battery control unit detected a signal on circuit "K" higher than the expected maximum. This often comes from a problem in the measurement circuit, such as a short to a power supply or a broken wire. The exact meaning of the letter K depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or limp mode
Unstable or wrong charge indication
Limited or interrupted charging
High-voltage system that does not activate in more serious cases
Common causes
Damaged connector or dirty contacts
Broken measurement wire or resistance that is too high
Faulty battery pack control electronics
Cell group with a genuinely too high voltage
What to do
How to read code P0B70
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0B70 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (70) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0B70 mean?
HV battery voltage sense circuit K: signal too high. The high-voltage battery control unit detected a signal on circuit "K" higher than the expected maximum. This often comes from a problem in the measurement circuit, such as a short to a power supply or a broken wire. The exact meaning of the letter K depends on the manufacturer.
Can I keep driving with code P0B70 active?
With caution: limp mode possible, have it checked soon
Common causes — P0B70
Measurement wire shorted to a power supply Damaged connector or dirty contacts Broken measurement wire or resistance that is too high Faulty battery pack control electronics Cell group with a genuinely too high voltage
How do you fix code P0B70?
Have the wiring and connectors of the measurement circuit checked, and the measured voltages compared with the real ones. The battery pack must not be opened or touched except by staff trained for high voltage. With the light on and reduced power, have the car checked without waiting.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0B6F — HV battery voltage sense circuit K: signal too low
- Next code: P0B71 — HV battery voltage sense circuit K: erratic signal
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high