P0B79 — HV battery voltage sense circuit M: signal too low
| Meaning | The control unit measured a signal on circuit "M" lower than the expected minimum. This usually points to an electrical problem in the measurement circuit, such as a wire shorted to ground or broken, rather than a discharged cell. The meaning of M depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or limp mode
Wrong charge indication
Limited charging or regenerative braking
Hard or impossible start
Common causes
Connector with broken or oxidized contact
Broken measurement wire
Faulty battery pack control electronics
Cell group with a genuinely very low voltage
What to do
How to read code P0B79
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0B79 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (79) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0B79 mean?
HV battery voltage sense circuit M: signal too low. The control unit measured a signal on circuit "M" lower than the expected minimum. This usually points to an electrical problem in the measurement circuit, such as a wire shorted to ground or broken, rather than a discharged cell. The meaning of M depends on the manufacturer.
Can I keep driving with code P0B79 active?
With caution: limp mode possible, have it checked soon
Common causes — P0B79
Measurement wire shorted to ground Connector with broken or oxidized contact Broken measurement wire Faulty battery pack control electronics Cell group with a genuinely very low voltage
How do you fix code P0B79?
Have the wiring and connectors of the measurement circuit checked, and the voltage read compared with the real one. The battery pack must only be touched by staff trained for high voltage. If power drops a lot, avoid using the car.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0B78 — HV battery voltage sense circuit M: reading not pl...
- Next code: P0B7A — HV battery voltage sense circuit M: signal too hig...
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high