P0B82 — HV battery voltage sensor 'O': implausible reading
| Meaning | The battery management controller found that the signal from one of the circuits measuring traction battery voltage, labelled O, does not match what is expected or what the other circuits report. The fault can be in the sensor, the wiring or the measurement itself. The letter O names the measuring point, but which group of cells it covers is set by the manufacturer, so brand-specific documentation is needed. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or the car in limp mode
State-of-charge display that jumps or looks wrong
Combustion engine running more often than usual
Trouble or inability to put the car in drive-ready state
Common causes
Damaged wire or abnormal resistance in the sensing circuit
Real voltage imbalance between cells or modules
Internal fault in the battery management controller
Moisture or corrosion inside the battery pack
What to do
How to read code P0B82
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0B82 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (82) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0B82 mean?
HV battery voltage sensor 'O': implausible reading. The battery management controller found that the signal from one of the circuits measuring traction battery voltage, labelled O, does not match what is expected or what the other circuits report. The fault can be in the sensor, the wiring or the measurement itself. The letter O names the measuring point, but which group of cells it covers is set by the manufacturer, so brand-specific documentation is needed.
Can I keep driving with code P0B82 active?
With caution: limp mode possible, have it checked soon
Common causes — P0B82
Corroded or poorly seated connector on the sensing harness Damaged wire or abnormal resistance in the sensing circuit Real voltage imbalance between cells or modules Internal fault in the battery management controller Moisture or corrosion inside the battery pack
How do you fix code P0B82?
Do not touch the orange cables and do not open the battery pack: high-voltage work is for qualified technicians only. Have the voltage of each cell group read out with a diagnostic tool to tell a measurement fault from a real battery problem. Don't leave it too long, as the car may limit power or fail to restart.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0B81 — HV battery voltage sense circuit O: circuit fault
- Next code: P0B83 — HV battery voltage sensor 'O': signal too low
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high