Skip to content
Fault code dictionary (DTC)

P0BA6 — HV battery voltage sense circuit V: signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe hybrid/EV battery control unit reads a voltage on sense circuit "V" that is lower than the expected minimum. The letter V identifies a monitored cell group, and which one depends on the manufacturer. The cause can be a broken or grounded wire, or a cell group that is genuinely low.
FamilyPowertrain (P)

Typical symptoms

Hybrid system or battery warning light on
Reduced power
Inconsistent charge level
Combustion engine on more than normal
Difficulty starting the system

Common causes

Broken sensing wire or poor contact
Wire shorted to ground
Loose or corroded connector
Very discharged or degraded cell group
Fault in the battery management unit

What to do

Qualified high-voltage staff are required. Connectors and wiring of circuit V are checked first, then the reading is compared with the real voltage. Do not clear the code, and if the car goes into protection mode, do not force it.

How to read code P0BA6

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0BA6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (A6) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0BA6 mean?

HV battery voltage sense circuit V: signal too low. The hybrid/EV battery control unit reads a voltage on sense circuit "V" that is lower than the expected minimum. The letter V identifies a monitored cell group, and which one depends on the manufacturer. The cause can be a broken or grounded wire, or a cell group that is genuinely low.

Can I keep driving with code P0BA6 active?

With caution: limp mode possible, have it checked soon

Common causes — P0BA6

Broken sensing wire or poor contact Wire shorted to ground Loose or corroded connector Very discharged or degraded cell group Fault in the battery management unit

How do you fix code P0BA6?

Qualified high-voltage staff are required. Connectors and wiring of circuit V are checked first, then the reading is compared with the real voltage. Do not clear the code, and if the car goes into protection mode, do not force it.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes