Skip to content
Fault code dictionary (DTC)

P0BCF — Generator inverter temperature sensor A signal high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit reads an electrical signal that is too high from temperature sensor A of the generator inverter, typical of an open circuit or an unplugged sensor. The temperature reading is not reliable.
FamilyPowertrain (P)

Typical symptoms

Hybrid/electric system warning light on
Limited power
Limp mode
Inverter cooling working abnormally
Limited battery charging

Common causes

Sensor connector unplugged or loose
Broken sensor wire
Failed sensor
Corroded contacts
Inverter with a faulty sensor input

What to do

Have the connectors and wiring continuity of the sensor checked at a qualified workshop. Do not touch the inverter or orange cables. Do not wait too long.

How to read code P0BCF

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0BCF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (CF) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0BCF mean?

Generator inverter temperature sensor A signal high. The control unit reads an electrical signal that is too high from temperature sensor A of the generator inverter, typical of an open circuit or an unplugged sensor. The temperature reading is not reliable.

Can I keep driving with code P0BCF active?

With caution: limp mode possible, have it checked soon

Common causes — P0BCF

Sensor connector unplugged or loose Broken sensor wire Failed sensor Corroded contacts Inverter with a faulty sensor input

How do you fix code P0BCF?

Have the connectors and wiring continuity of the sensor checked at a qualified workshop. Do not touch the inverter or orange cables. Do not wait too long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes