P0BDA — Inverter temperature sensor D: unstable signal
| Meaning | The control unit saw the signal from inverter temperature sensor D drop out and return, or jump suddenly in ways real temperature cannot. This points to a contact that breaks at times, from vibration or moisture. The fault can disappear and come back, so do not dismiss it just because the warning light goes off. |
| Family | Powertrain (P) |
Typical symptoms
Occasional loss of power, especially on rough roads
Warning message appearing and disappearing
Inverter temperature value jumping on the diagnostic tool
Cooling fans changing speed for no reason
Common causes
Wiring with a partly broken or chafed wire
Corrosion or moisture in the terminals
Faulty inverter temperature sensor
Internal fault in the inverter or its control board
What to do
How to read code P0BDA
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0BDA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (DA) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0BDA mean?
Inverter temperature sensor D: unstable signal. The control unit saw the signal from inverter temperature sensor D drop out and return, or jump suddenly in ways real temperature cannot. This points to a contact that breaks at times, from vibration or moisture. The fault can disappear and come back, so do not dismiss it just because the warning light goes off.
Can I keep driving with code P0BDA active?
With caution: limp mode possible, have it checked soon
Common causes — P0BDA
Sensor connector with unstable contact Wiring with a partly broken or chafed wire Corrosion or moisture in the terminals Faulty inverter temperature sensor Internal fault in the inverter or its control board
How do you fix code P0BDA?
With a diagnostic tool, watch the value of sensor D while gently moving the wiring and connectors: a sudden jump shows where the problem is. Also check for moisture and corrosion on the terminals. An intermittent fault tends to get worse, so have it checked by a workshop qualified for high-voltage work without waiting too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0BD9 — Inverter temperature sensor D: signal too high
- Next code: P0BDB — Inverter temperature sensor E circuit fault
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high