Skip to content
Fault code dictionary (DTC)

P0BFA — Motor B phase W current sensor signal out of range

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe motor control unit found that the current sensor on phase W of drive motor B gives a value that does not make sense compared with what it expects. Motor B is the vehicle's second electric motor; which one that is depends on the manufacturer. This sensor measures the current the inverter sends to the motor, so a wrong reading stops the motor from being controlled accurately.
FamilyPowertrain (P)

Typical symptoms

Hybrid or electric system warning light on
Reduced power or limp mode
Jerky or uneven electric drive
Combustion engine working more than usual (hybrids)
Warning message in the instrument cluster

Common causes

Poor contact in the sensor connector or wiring
Faulty phase W current sensor
Internal fault in the inverter or its control board
Damaged or loose phase cable
Electrical noise caused by a weak low-voltage supply

What to do

Do not touch the orange high-voltage cables: this needs a workshop qualified for electric and hybrid vehicles. First checks are connectors, wiring and the live readings of the phase currents. Avoid continued driving, since the car may cut power suddenly.

How to read code P0BFA

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0BFA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (FA) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0BFA mean?

Motor B phase W current sensor signal out of range. The motor control unit found that the current sensor on phase W of drive motor B gives a value that does not make sense compared with what it expects. Motor B is the vehicle's second electric motor; which one that is depends on the manufacturer. This sensor measures the current the inverter sends to the motor, so a wrong reading stops the motor from being controlled accurately.

Can I keep driving with code P0BFA active?

With caution: limp mode possible, have it checked soon

Common causes — P0BFA

Poor contact in the sensor connector or wiring Faulty phase W current sensor Internal fault in the inverter or its control board Damaged or loose phase cable Electrical noise caused by a weak low-voltage supply

How do you fix code P0BFA?

Do not touch the orange high-voltage cables: this needs a workshop qualified for electric and hybrid vehicles. First checks are connectors, wiring and the live readings of the phase currents. Avoid continued driving, since the car may cut power suddenly.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes