P0BFC — Motor B phase W current sensor signal too high
| Meaning | The control unit found that the phase W current sensor circuit of motor B returns a voltage higher than the expected maximum. It can come from a short to supply voltage, a poor ground connection or a faulty sensor. The reading cannot be trusted, and the system may limit the motor as a precaution. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power
Jerky behavior under acceleration
Forced switch to limp mode
Fault message in the instrument cluster
Common causes
Open or poor sensor ground
Faulty phase W current sensor
Damaged or wet connector
Internal inverter fault
What to do
How to read code P0BFC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0BFC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (FC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0BFC mean?
Motor B phase W current sensor signal too high. The control unit found that the phase W current sensor circuit of motor B returns a voltage higher than the expected maximum. It can come from a short to supply voltage, a poor ground connection or a faulty sensor. The reading cannot be trusted, and the system may limit the motor as a precaution.
Can I keep driving with code P0BFC active?
With caution: limp mode possible, have it checked soon
Common causes — P0BFC
Signal wire touching a supply voltage Open or poor sensor ground Faulty phase W current sensor Damaged or wet connector Internal inverter fault
How do you fix code P0BFC?
Go to a workshop qualified for high-voltage vehicles. First step is to check ground, supply and wiring of the sensor and read the live data. Better to use the car as little as possible until it has been checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0BFB — Motor B phase W current sensor signal too low
- Next code: P0BFD — Motor A current sensors: three phase readings disa...
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high