P0C31 — Inverter B cooling system performance
| Meaning | The control unit found that the system cooling inverter B does not remove heat as it should. The inverter is the electronics that convert current between the battery and the electric motor, and it gets very hot. If it is not cooled well, the system reduces power to protect itself. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power, especially uphill or under load
Cooling fan always at maximum
Limited electric drive
Coolant temperature higher than usual
Common causes
Failed electric coolant pump
Dirty or blocked radiator
Air in the circuit or blocked hoses
Unreliable inverter temperature sensor
Fan not running properly
What to do
How to read code P0C31
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C31 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (31) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C31 mean?
Inverter B cooling system performance. The control unit found that the system cooling inverter B does not remove heat as it should. The inverter is the electronics that convert current between the battery and the electric motor, and it gets very hot. If it is not cooled well, the system reduces power to protect itself.
Can I keep driving with code P0C31 active?
With caution: limp mode possible, have it checked soon
Common causes — P0C31
Low coolant level in the inverter circuit Failed electric coolant pump Dirty or blocked radiator Air in the circuit or blocked hoses Unreliable inverter temperature sensor Fan not running properly
How do you fix code P0C31?
Check the level in the dedicated coolant reservoir right away, cold and with the system off, and have the pump and fan checked. Do not keep driving hard if the temperature rises, because the inverter can be damaged.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C30 — Hybrid/EV battery pack state of charge too high
- Next code: P0C32 — Hybrid/EV battery cooling system A performance
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open