Skip to content
Fault code dictionary (DTC)

P0C5E — Drive motor A position sensor circuit B: erratic signal

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe hybrid/EV control unit detected that the signal from the position sensor (resolver) of drive motor A, on circuit B, drops in and out or is irregular. This sensor tells the controller where the rotor is, and without a reliable reading the motor cannot be driven accurately. The fault is intermittent, so it may disappear and come back.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV system warning light on, sometimes only on and off
Loss of power or jerky delivery
Vibration or shuddering when accelerating
Vehicle going into reduced-power (limp) mode
Hard starting or sudden shutdown while driving

Common causes

Corroded or poorly seated sensor or harness connector
Chafed or damaged wire from vibration
Moisture getting into the connector
Faulty position sensor (resolver)
Problem in the inverter or motor control unit

What to do

Have the sensor connectors and wiring checked soon, since a poor contact is the most common cause. If the car goes into reduced-power mode or shuts down while driving, stop using it and have it taken to a workshop. Do not clear the code without finding the cause: it will come back.

How to read code P0C5E

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0C5E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (5E) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0C5E mean?

Drive motor A position sensor circuit B: erratic signal. The hybrid/EV control unit detected that the signal from the position sensor (resolver) of drive motor A, on circuit B, drops in and out or is irregular. This sensor tells the controller where the rotor is, and without a reliable reading the motor cannot be driven accurately. The fault is intermittent, so it may disappear and come back.

Can I keep driving with code P0C5E active?

With caution: limp mode possible, have it checked soon

Common causes — P0C5E

Corroded or poorly seated sensor or harness connector Chafed or damaged wire from vibration Moisture getting into the connector Faulty position sensor (resolver) Problem in the inverter or motor control unit

How do you fix code P0C5E?

Have the sensor connectors and wiring checked soon, since a poor contact is the most common cause. If the car goes into reduced-power mode or shuts down while driving, stop using it and have it taken to a workshop. Do not clear the code without finding the cause: it will come back.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes