Skip to content
Fault code dictionary (DTC)

P0CAB — Battery temperature sensor M: signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit reads a voltage from temperature sensor M that is higher than the expected maximum. It usually points to an open circuit: a broken wire, an unplugged connector or a failed sensor. The location of M depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV warning light on
Battery temperature read as very low
Limited power or charging
Odd battery fan behavior
Reduced range

Common causes

Open signal wire
Unplugged or corroded connector
Failed temperature sensor
Weak contact at the control module
Faulty battery control module

What to do

Have the connector and wire continuity checked first, then the sensor resistance. High-voltage work only by qualified staff. Avoid fast charging and heavy use until it is fixed.

How to read code P0CAB

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0CAB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (AB) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0CAB mean?

Battery temperature sensor M: signal too high. The control unit reads a voltage from temperature sensor M that is higher than the expected maximum. It usually points to an open circuit: a broken wire, an unplugged connector or a failed sensor. The location of M depends on the manufacturer.

Can I keep driving with code P0CAB active?

With caution: limp mode possible, have it checked soon

Common causes — P0CAB

Open signal wire Unplugged or corroded connector Failed temperature sensor Weak contact at the control module Faulty battery control module

How do you fix code P0CAB?

Have the connector and wire continuity checked first, then the sensor resistance. High-voltage work only by qualified staff. Avoid fast charging and heavy use until it is fixed.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes