Skip to content
Fault code dictionary (DTC)

P0CAF — HV battery temp sensor N: signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe battery control unit detected a lower than normal voltage on the circuit of temperature sensor N. In practice the signal looks as if it were shorted to ground, or the sensor reports an impossible temperature. Which sensor in the pack is N depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV system warning light on
Limited power or limp mode
Charging slowed or stopped
Battery fan always running or irregular
Nonsensical or missing battery temperature on the display

Common causes

Pinched sensor wiring or damaged insulation touching ground
Internally shorted sensor
Wet or moisture-affected connector
Fault in the battery management unit
Damage inside the battery pack

What to do

Start with a visual check of accessible connectors and wiring, looking for moisture, pinching or chafing. Then a technician needs to measure the sensor signal and compare it with the manufacturer's values. Don't drive for long with the light on: without a correct reading the battery is not being monitored properly. Work on high voltage is for qualified personnel only.

How to read code P0CAF

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0CAF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (AF) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0CAF mean?

HV battery temp sensor N: signal too low. The battery control unit detected a lower than normal voltage on the circuit of temperature sensor N. In practice the signal looks as if it were shorted to ground, or the sensor reports an impossible temperature. Which sensor in the pack is N depends on the manufacturer.

Can I keep driving with code P0CAF active?

With caution: limp mode possible, have it checked soon

Common causes — P0CAF

Pinched sensor wiring or damaged insulation touching ground Internally shorted sensor Wet or moisture-affected connector Fault in the battery management unit Damage inside the battery pack

How do you fix code P0CAF?

Start with a visual check of accessible connectors and wiring, looking for moisture, pinching or chafing. Then a technician needs to measure the sensor signal and compare it with the manufacturer's values. Don't drive for long with the light on: without a correct reading the battery is not being monitored properly. Work on high voltage is for qualified personnel only.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes