Skip to content
Fault code dictionary (DTC)

P0CB5 — HV battery temp sensor O: signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe battery control unit detected a higher than normal voltage on the circuit of temperature sensor O. Usually the circuit is open, the connector is not making contact, or the sensor has failed. Which sensor in the pack is O depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV system warning light on
Reduced power or limp mode
Limited charging
Battery fan running when it shouldn't, or not running
Missing or inconsistent battery temperature reading

Common causes

Loose or corroded connector
Broken sensor wire or wire pulled out of its terminal
Internally failed sensor
Cut or worn wiring
Fault in the battery management unit

What to do

First have the circuit continuity and the connectors checked. If the fault comes and goes, suspect a poor contact. It is better to act soon, because the battery loses a safety check on its temperature. High voltage work requires qualified personnel.

How to read code P0CB5

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0CB5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (B5) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0CB5 mean?

HV battery temp sensor O: signal too high. The battery control unit detected a higher than normal voltage on the circuit of temperature sensor O. Usually the circuit is open, the connector is not making contact, or the sensor has failed. Which sensor in the pack is O depends on the manufacturer.

Can I keep driving with code P0CB5 active?

With caution: limp mode possible, have it checked soon

Common causes — P0CB5

Loose or corroded connector Broken sensor wire or wire pulled out of its terminal Internally failed sensor Cut or worn wiring Fault in the battery management unit

How do you fix code P0CB5?

First have the circuit continuity and the connectors checked. If the fault comes and goes, suspect a poor contact. It is better to act soon, because the battery loses a safety check on its temperature. High voltage work requires qualified personnel.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes